Jump to content

Wrong head in "wrong" place..


Recommended Posts

Posted · Wrong head in "wrong" place..

I accidentally mounted the first head in the right position (most towards the back).. And when reading the guide I should have the right (second) head a bit higher than the first?!

Would it be possible for me just to have the left a bit higher (as this is my second head) than the other one? Or do I need to switch place on these two (I think i just can switch cables though)?

Regards

</Jonas>

 

  • Link to post
    Share on other sites

    Posted · Wrong head in "wrong" place..

    sorry, mist your post earlier...

    Change the wiring would be enough I guess.

    Mounting of the hotends is the same as well, so you should be able to adjust the front one a little higher.

    While printing you need them at exactly at the same height.

    X/Y offset's can stay the same, when selecting the print in cura, remember that (standard) green coloured part is for hotend 1 and the red is for 2.

    I think youre printing area is about 20 mm smaller, be careful with that!!

    Hotend 2 hits your bed levelling screws in the back, countersink those anyhow to avoid damage. But the print will fall of the bed. you loose 20mm in the front of the machine.

     

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
    • Our picks

      • UltiMaker Cura 5.8 Stable released 🎉
        In the Cura 5.8 stable release, everyone can now tune their Z seams to look better than ever. Method series users get access to new material profiles, and the base Method model now has a printer profile, meaning the whole Method series is now supported in Cura!
        • 5 replies
      • Introducing the UltiMaker Factor 4
        We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications
          • Thanks
          • Like
        • 3 replies
    ×
    ×
    • Create New...