Jump to content
Reywas

Line Width vs Line Spacing

Recommended Posts

Posted (edited) · Line Width vs Line Spacing

It is my understanding that, in Cura,  the center-to-center line spacing is equal to the Line Width setting.  If so, for a calibrated extruder where printing two walls of 0.5mm gives a measured thickness of 1mm, is there any overlap between the two walls?  I know there must be but I can't wrap my brain around how this works.  In PrusaSlicer, the line width doesn't equal the line spacing, giving the needed overlap.

Edited by Reywas

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×
×
  • Create New...

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!