Jump to content
Ultimaker Community of 3D Printing Experts

printing Surface model with dual extruders


Recommended Posts

Posted · printing Surface model with dual extruders


I'm trying to print a very thin (single wall), dual extruded model.

I made "only surfaces model" in Solid Works (extruded surfaces).

I use "surface mode" in the special modes of Cura 4.5.


For some reason you can see in the preview that only one extruder is printing and the other is doint first layer only. 

I attached the two surface models and a picture of the preview.


any Idea on how to fix it?

surface print problem.jpg


  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now

    • Our picks

      • Ultimaker showcase | April 2022 | 4pm CEST | 10am EDT
        I'm excited because I've personally produced this showcase event, so if you are curious what else I'm up to nowadays, come check it out and say hi in the chat! It would mean a lot! 
          • Thanks
          • Like
        • 4 replies
      • New here? Get ahead with a free onboarding course
        Often getting started is the most difficult part of any process. A good start sets you up for success and saves you time and energy that could be spent elsewhere. That is why we have a onboarding course ready for
        Ultimaker S5 Pro Bundle, Ultimaker S5, Ultimaker S3 Ultimaker 2+ Connect.   
        They're ready for you on the Ultimaker Academy platform. All you need to do to gain access is to register your product to gain free access. 
        Ready? Register your product here in just 60 seconds.
          • Like
        • 12 replies
    • Create New...