Print stopped. Filament change requested

[fogobo 0]

48 hours in and the printer stopped (Ender 3 pro) It asked about filament change. Is there a setting I'm forgetting?

[Guest maht]

Sounds like you've enabled a post processing script when slicing. Did you do this?

[fogobo 0]

Nope. I looked at that. No scrips were shown at all. My printer was running for about 3:12:00 when it stopped. The percentage of completion shown on the printer's control panel reached 100%. I am sure it stopped at 100%. There was about 1/3 left to print.  It was suppose to take 5:29:19

[Guest maht]

That's weird. Upload a project file and I can take a look?

(File > Save...)

 

I have a feeling this is a firmware issue with Ender 3 machines, I seem to remember something similar reported before...