Jump to content

Interior layers and infil using thicker layers and wider nozzle

oliverracing

By oliverracing
in UltiMaker Cura

 Share

Recommended Posts

oliverracing

oliverracing 0

Posted
Posted (edited) · Interior layers and infil using thicker layers and wider nozzle

Got a dual nozzle setup on my printer, 0.4 and 0.8mm and want to improve print speeds while not having to use a 0.8mm nozzle for exterior surfaces. 

 

What I dream of doing is printing the outer one or two shell with a 0.4mm nozzle, at 0.25mm layer height then another interior shell with a 0.8mm nozzle with 0.5mm layer height. 

 

This of course would need to do two of the thin layers for every thick layer, but this is already done for the print infill at higher layer heights so must be doable? 

 

How can I do this and if not is it on the horizon for being doable? 

Edited by oliverracing
    • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
     Share
    Go to topic listing

    • Our picks

      • UltiMaker Cura 5.7 stable released

        UltiMaker Cura 5.7 stable released

        ArunC posted a topic in UltiMaker Cura,

        Cura 5.7 is here and it brings a handy new workflow improvement when using Thingiverse and Cura together, as well as additional capabilities for Method series printers, and a powerful way of sharing print settings using new printer-agnostic project files! Read on to find out about all of these improvements and more. 
         
          • Like
        • 18 replies
        MariMakes

        Picked By

        MariMakes,

      • Release Notes: S-Line Firmware 8.3.0 (Latest)

        Dustin posted a topic in Firmware,

        S-Line Firmware 8.3.0 was released Nov. 20th on the "Latest" firmware branch.
        (Sorry, was out of office when this released)

        This update is for...
        All UltiMaker S series  
        New features
         
        Temperature status. During print preparation, the temperatures of the print cores and build plate will be shown on the display. This gives a better indication of the progress and remaining wait time. Save log files in paused state. It is now possible to save the printer's log files to USB if the currently active print job is paused. Previously, the Dump logs to USB option was only enabled if the printer was in idle state. Confirm print removal via Digital Factory. If the printer is connected to the Digital Factory, it is now possible to confirm the removal of a previous print job via the Digital Factory interface. This is useful in situations where the build plate is clear, but the operator forgot to select Confirm removal on the printer’s display. Visit this page for more information about this feature.
        • 0 replies
        MariMakes

        Picked By

        MariMakes,
      View All
    ×
    ×
    • Create New...