I have been trying to set up Cura to work with my Ender 3. I have a Easy ABL for leveling, and a Micro swiss direct drive hot end.

[MDelke 0]

I have been trying for over a week to get Cura set up to work with my Ender 3

mods are EZABL for bed leveling

                Micro swiss direct drive hot end

I went into Cura 5.6.0 picked the Ender 3 printer, went to settings, printer, manage printers to make the adjustent so that the EZABLE could work.

Tried to replace the starting G code, I can erase the old code but cannot paste the new code into Cura.....( I know the code is good as it came from a power Cura user)

also

there is no where that I can find to enter the X Y offsets to keep my hot end over the print bed.

 

What is the proper way to add bed leveling to this printer set up in Cura.

 

Thank You

 

MDelke