Ok. Nozzle is 0,4 mm. Dry filament. Not tried, flow settings should be changed?
Ok. Nozzle is 0,4 mm. Dry filament. Not tried, flow settings should be changed?
Right, if you are pointing out print defects, let's see what's creating them.
The link I sent will demonstrate how to print a calibration cube. With flow at 100%, print the cube and use calipers to measure the average of the 4 wall thickness. That will tell you if you are over or under extruding.
Recommended Posts
LePaul 336
Let's start with the basics.
Dry filament?
Have you dialed in the flow settings? See here
What size nozzle/core?
Link to post
Share on other sites