Jump to content
Ultimaker Community of 3D Printing Experts
Sign in to follow this  

Feed Motor?

Recommended Posts

I have set up my Ultimaker and will "print" using Cura. However the feed motor isn't feeding any PLA to the extruder. I have been banging my head against a wall trying to figure out what is going on. Any help would be appreciated.

Share this post

Link to post
Share on other sites

Is the feed motor turning or not?

If it isn't turning then the problem could be in electronics. First check all the electrical connections.

Share this post

Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this  

  • Our picks

    • "Back To The Future" using Generative Design & Investment Casting
      Designing for light-weight parts is becoming more important, and I’m a firm believer in the need to produce lighter weight, less over-engineered parts for the future. This is for sustainability reasons because we need to be using less raw materials and, in things like transportation, it impacts the energy usage of the product during it’s service life.
        • Like
      • 12 replies

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!