UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
I keep having feed rate issues. The knurled bolt keeps eating away at the material. I cant even print anything with out it happening. I have tried cleaning the bolt, two different materials from two different manufacturers, helping feed it, different temperatures. What am I doing wrong?
thank you for the help.
Rob
Hi Rob,
- If the tension screw is too tight, the filament will eat away at the material. Check out the following videos from Jeorgen....
- If the diameter of the filament is greater than the inner diamter of the bowden tube, you will get a jam at the cold end. I had
this problem with the stock UM filament (silver one) that i received with the kit. Also, if the bolt eats away at the filament, it can deform it, thus causing a
jam at the cold end
- Are you printing at high enough temperature? The temperature reading that I get is off by 25-30 degrees (which tested with a multimeter). So when I
was printing at 205 degrees (it was really about 180 degress) which was causing very little extrusion and filament stripping at the cold end. Eventually when I was printing at real temp of 220-225 then things started to flow better..
- Is the hot end of your bowden jammed? If your fialment diamter is the right size..and at a high enough temp( 230 degrees) can you easily
push the filament manually? If not, then your hot end of the bowden might be jammed..
In the Cura 5.8 stable release, everyone can now tune their Z seams to look better than ever. Method series users get access to new material profiles, and the base Method model now has a printer profile, meaning the whole Method series is now supported in Cura!
We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications
Recommended Posts
approx 0
Hi Rob,
- If the tension screw is too tight, the filament will eat away at the material. Check out the following videos from Jeorgen....
Filament pressure:
http://db.tt/zVcKL9q0
Bolt tightening:
http://db.tt/j95qMlaQ
Filament-Bowden-Peek transition 1:
http://db.tt/FVAU7hiH
Filament-Bowden-Peek transition 2:
http://db.tt/Ag7OpbbT
Filament-Bowden-Peek transition 3:
http://db.tt/Kd3kPPrg
- If the diameter of the filament is greater than the inner diamter of the bowden tube, you will get a jam at the cold end. I had
this problem with the stock UM filament (silver one) that i received with the kit. Also, if the bolt eats away at the filament, it can deform it, thus causing a
jam at the cold end
- Are you printing at high enough temperature? The temperature reading that I get is off by 25-30 degrees (which tested with a multimeter). So when I
was printing at 205 degrees (it was really about 180 degress) which was causing very little extrusion and filament stripping at the cold end. Eventually when I was printing at real temp of 220-225 then things started to flow better..
- Is the hot end of your bowden jammed? If your fialment diamter is the right size..and at a high enough temp( 230 degrees) can you easily
push the filament manually? If not, then your hot end of the bowden might be jammed..
Link to post
Share on other sites