UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
If you clamp down the 4 mount screws on the head too hard, the tube gets pushed into the peek part too hard, deforms and restricts the filament to a point where it can't get through anymore. if you push it through by hand, you should see and feel where the obstruction is exactly. the same with owens clamp (i think).
In the Cura 5.8 stable release, everyone can now tune their Z seams to look better than ever. Method series users get access to new material profiles, and the base Method model now has a printer profile, meaning the whole Method series is now supported in Cura!
We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications
Recommended Posts
joergen 2
If you clamp down the 4 mount screws on the head too hard, the tube gets pushed into the peek part too hard, deforms and restricts the filament to a point where it can't get through anymore. if you push it through by hand, you should see and feel where the obstruction is exactly. the same with owens clamp (i think).
Link to post
Share on other sites