Jump to content

Pushing knob on controller has no effect.


eric-van-orsouw

Recommended Posts

Posted · Pushing knob on controller has no effect.

I have just assembled my new Ultimaker Original+.

Via USB cable I have been able to print the Ultimaker robot successfully!

The controller display properly shows the temperatures and stuff upon start.

Turning the knob changes the FR factor.

However pushing the knob has no effect, meaning I cannot enter the menu.

I have verified that the signal of pushing the knob on the controller actually arrives on the main processor board on the bottom.

Cura installed the latest firmware 'MarlinUltimaker-UMOP-250000.hex' on the machine.

Anyone any ideas?

 

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
    • Our picks

      • UltiMaker Cura 5.8 Stable released 🎉
        In the Cura 5.8 stable release, everyone can now tune their Z seams to look better than ever. Method series users get access to new material profiles, and the base Method model now has a printer profile, meaning the whole Method series is now supported in Cura!
        • 5 replies
      • Introducing the UltiMaker Factor 4
        We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications
          • Thanks
          • Like
        • 3 replies
    ×
    ×
    • Create New...