UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
If you print with USB, you will run into buffering problems, causing stutter. But if you print from SD card with an UltiController, you will do fine.
It does take a insane amount of time to slice something that large. You can try slicing with RepG or Cura without having an UltiMaker. If it slices, it should print with the UltiController.
In the Cura 5.8 stable release, everyone can now tune their Z seams to look better than ever. Method series users get access to new material profiles, and the base Method model now has a printer profile, meaning the whole Method series is now supported in Cura!
We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications
Recommended Posts
Daid 306
If you print with USB, you will run into buffering problems, causing stutter. But if you print from SD card with an UltiController, you will do fine.
It does take a insane amount of time to slice something that large. You can try slicing with RepG or Cura without having an UltiMaker. If it slices, it should print with the UltiController.
Link to post
Share on other sites