Jump to content

OK to connect USB after UltiController Jumper made?

lino

By lino
in UltiMaker 3D printers

 Share

Recommended Posts

lino

lino 0

Posted
Posted · OK to connect USB after UltiController Jumper made?

Hello,

I just wanted to verify that it was still OK to connect the USB cable to the Ultimaker after the jumper has been made on V1.5.4 to power the USB on board. I suspect it's not an issue, but I wanted to make sure it was OK and that no damage could occur to connected computer or to Ultimaker. Thanks!

ciao

lino

    • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
     Share
    Go to topic listing

    • Our picks

      • UltiMaker Cura 5.8 beta released

        UltiMaker Cura 5.8 beta released

        ArunC posted a topic in UltiMaker Cura,

        Another Cura release has arrived and in this 5.8 beta release, the focus is on improving Z seams, as well as completing support for the full Method series of printers by introducing a profile for the UltiMaker Method.
          • Like
        • 1 reply
        MariMakes

        Picked By

        MariMakes,
      • Introducing the UltiMaker Factor 4

        Introducing the UltiMaker Factor 4

        ArunC posted a topic in UltiMaker 3D printers,

        We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications
          • Thanks
          • Like
        • 3 replies
        MariMakes

        Picked By

        MariMakes,
      View All
    ×
    ×
    • Create New...