Jump to content

Error stopped - Temp sensor bed


calimero

Recommended Posts

Posted (edited) · Error stopped - Temp sensor bed

Hi

Tonight after a few weeks without any printing I switched from PLA back to ABS.

I then heated up the bed and initiated a new print. Once the bed and nozzle were at the right temp, the bed was raised to start printing.

But that's when things went wrong. As the bed was moving up it sounded like a missed step and I was instantly graced with a "Temp sensor bed" error.

I power cycled the printer and the print sensor seems to work and give credible figures.

Here's a video of the bed being raised and lowered. At 00:35 the weird sound can be heard (and again the printer goes in error mode). Surprisingly I've been able to lower/raise the bed a few times without problems. But most attempts (usually raising) fail with that weird noise.

 

Note: buzzing at 00:15 is unrelated to the printer . I just got a text on my smartphone...

Cables going to the bed seem fine and are out of the way when bed is travelling up or down.

Any idea where to look ?

Thanks

Edited by Guest
  • Link to post
    Share on other sites

    Posted · Error stopped - Temp sensor bed

    I've come to think that it might indeed be a simple connection issue. I've wiggled the cable on the bed end and have been able to move the bed up/down multiple times and run a 1-hour print.

    The brief connection issue causes the printer to go into error mode. Maybe that brutal change somehow interrupts the code running the stepper motors for a few cycles hence what sounds like a missed step ?

    Anyway I'll try check the cable tonight a bit more carefully.

    Good to have the build manual. Thanks.

  • Link to post
    Share on other sites

    • 1 year later...
    Posted · Error stopped - Temp sensor bed

    Hi All,

    I've got the same error with after the SAME weird sound (at 00:35 in your video)

    I've check the wire, the connector and every things OK but my Ultimaker say "ERROR STOP - Temp sensor Bed"

    Can you help me ?

    Thanks

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
    • Our picks

      • Introducing the UltiMaker Factor 4
        We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications
          • Thanks
          • Like
        • 3 replies
      • UltiMaker Cura 5.7 stable released
        Cura 5.7 is here and it brings a handy new workflow improvement when using Thingiverse and Cura together, as well as additional capabilities for Method series printers, and a powerful way of sharing print settings using new printer-agnostic project files! Read on to find out about all of these improvements and more. 
         
          • Like
        • 26 replies
    ×
    ×
    • Create New...