Jump to content
Ultimaker Community of 3D Printing Experts

Test mit Slic3r


daim
 Share

Recommended Posts

Posted · Test mit Slic3r

Hallo zusammen,

ich wollte mal ein Test mit Slic3r fahren. Das klappt soweit auch nur wird der Top Layer nicht ganz geschlossen (siehe Bild), es bleibt immer Luft zu Rand. Kennst sich evtl. jemand mit der Software aus der einen Tipp für mich hat? Bei Cura hatte ich bisher keine Probleme... Fehler_Spalt_PLA_Grey.thumb.jpg.14137171e459706ea54ea6301e34aeee.jpg

Fehler_Spalt_PLA_Grey.thumb.jpg.14137171e459706ea54ea6301e34aeee.jpg

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
     Share

    • Our picks

      • Ultimaker showcase | April 2022 | 4pm CEST | 10am EDT
        I'm excited because I've personally produced this showcase event, so if you are curious what else I'm up to nowadays, come check it out and say hi in the chat! It would mean a lot! 
          • Thanks
          • Like
        • 4 replies
      • New here? Get ahead with a free onboarding course
        Hi,
         
        Often getting started is the most difficult part of any process. A good start sets you up for success and saves you time and energy that could be spent elsewhere. That is why we have a onboarding course ready for
        Ultimaker S5 Pro Bundle, Ultimaker S5, Ultimaker S3 Ultimaker 2+ Connect.   
        They're ready for you on the Ultimaker Academy platform. All you need to do to gain access is to register your product to gain free access. 
        Ready? Register your product here in just 60 seconds.
          • Like
        • 12 replies
    ×
    ×
    • Create New...