Hello,
This is sort of overboard here but I thought I should ask...
I have a PrintrBot 1403 printer. It works. The motors are good, the Klipper source works, and the board is okay and fast (Recore). Anyway, outside of plugging other peoples' works, I need support.
Every time I slice in CURA 4.13.1, I end up with negative values in the X-axis that creates my OctoPrint instance to go into error mode.
Is there a way to slice in CURA from thingiverse and have non-negative values for the X-axis for printing with my setup?
Seth
P.S. I know this is a lot to ask. I do not know where to reach out about this concern. So, if you have time and are using a PrintrBot 1403, please reply. I know this is an older model printer. The person that was in charge of mfg. this printer is back in business. This may be something to look forward to currently. I still have an issue, i.e. as their site has not been fully functional yet.
I am using Marlin as the type. I will go into settings and see if anything is altered or needs to be changed in the meantime.