Hi,
I started testing the new PA from colorfabb: A minimum hot-end temperature of 260C is recommended and a heated bed at 40C / 50C is advised
But my UM2+ restarts (black screen, stops extruding, restarts and shows the default menu) during the print of the second layer: slicer S3D; hot-end temperature 260°C; bed 50°C
What I tested:
Different parts: same problem
Different slicer: same problem with cura (restarts after approx. 4th layer)
Control of the hot-end temperature : The restarts happen with a hot-end temperatur of 259-260 °C
Reducing the bed temperature: 50/40/30 °C same problem
The solution:
Disable the heated bed or T<20°C and the prints are fine
But what I don't understand, I don't have any problems printing nGen (hot-end 227°C, bed 80°C)
The hot-end should be fine: can print 260°C
The bed should be fine: can print nGen with 80°C bed
The power supply should be fine ? Printing with a 80°C bed should consume more power than printing 260°C?
Is it the mainboard? The UM2+ should be able to print 260°C with a heated bed?
I need the heated bed for better adhesion and avoiding wrapping.
Thanks for your help!