Hello All!
Long time reader, first time poster.
I've just finished installing my Mark2 upgrade, it's looking incredible, thank you to all the developers for their hard work.
I'll post some pictures of finished prints but seem to be having a few problems with my power supply. I've got the correct supply however when heating the bed and the nozzles, as soon as the bed is of the right temperature, the machine cuts out and restarts.
I thought this may have something to do with the bed heater using too much power so knocked it down from 60 to 30 degrees but I still encountered the same problem. I had a play around with the power budget in the firmware but with no luck sadly. I have been able to do a couple of calibration prints so this issue doesn't occur all the time but still a problem nevertheless. Anyone have any thoughts?
Thanks in advance, looking forward to becoming part of the community.