I just upgraded from 3.41 to 3.6 and now I experience strange noises from the printer associated with either X or Y skipping. Marlin have not changed, and it sound like the printer get very fast movement instruction , such that the printer cannot handle. I tested this on my CR10 4S, (The Ceality have primary y axis skips). At first I checked my stepper, belt etc, the bed is smooth, eventualty I replace the driver chip, then the motherboard, reprogram Marlin, revert to Creality stock setting, but no avail. Then I moved my model (to fit smaller bed) and use the GCODE on my Prusa, and it it re-produce both x and y skipping, at the same height!, with the simular stepper noise. However if I print an old (save octaprint) GCODE the print is fine. I looks like Cura override some GCODE setting, or generate 'fast' movement code, but it has to do with speed. but unfortunately I am not a boffen on this subject. Have any one else seen this phenomena ?