waldo
-
Posts
37 -
Joined
-
Last visited
-
Days Won
1
Content Type
Forums
Events
3D Prints
Posts posted by waldo
-
-
I have about 1Kg of PVA - I'm going to put that to good use and than turn to BreakAway (as a lot of people are liking that so much better, it seems).
-
Printing PVA isn't working for me lately - result is a mess on the buildplate, and as you can see on the picture, the support even came lose under the chin of the second turtle.. . Also the eyes should have been filled with PVA...
The result is quite a mess of PVA all over the build plate...
Any ideas?
I used quite default settings - only the "overhang angle" was set to 55 (if I remember correctly...)
-
thanks, everyone!
-
I'm not sure that's an improvement 😉
bit I'll try!
-
I have no way to explain this, but as you can see on the picutre, every line has some "inaccuracies" on the same place, resulting in a vertical 'line'. You see two lines, by the way. It seems that the nozzle has been starting or stopping to extrude on that place for every layer .. dunno.
Do you have any idea how to prevent this?
-
I sometimes had this as well. I had the "feeling" the initial screw-height was to high. reasoning is when you manual level, you actually only screw up, never down ..
So what I do:
- start the manual leveling process. but before turning the wheel, turn all scrows down about 2 whole turns ...
- then start leveling.
that way, the initial level is quite a lot lower.. and the automatic leveling seems to be affected with it.
helps for me.
-
This is what happens during printing:
-
dit is dus wat er gebeurt tijdens het printen:
-
Werkt er hier iemand met Makerfill?
Ik probeer namelijk MakerFill Flex te printen, en zowat 50% van de prints mislukken. Na het vast komen zitten van het filament, ben ik wat beginnen aanpassen (temp omhoog, geen retraction, tragere snelheid), maar nu komt het tijdens het printen los van het printbed ... (ik heb het bed op 50 graden staan).
Heeft iemand tips/settings?
-
I'm using Makerfill Flex.
and I'm having issues printing it.. .
first, it got jammed, but I fixed that with a lower speed,and higher temperature.
Now, it gets loose from the bed after about 10 minutes of printing (flat surface). Also with a heated bed of 50 degrees C. Also with the out-of-the-box prit-stick.. .
Any tips?
-
On 12/6/2017 at 2:38 PM, robinmdh said:
your problem is different, just remove the circular paper/carboard that has the NFC tag and place that on the spool holder as proxy....
nice one!
Cura Connect - "frozen" print
in UltiMaker Cura
Posted
difficult to describe, but I have one print that is always showing up in CURA connect (Ultimaker 3):
I printed that like 4 weeks ago. It was a failed print which I aborted. This is no way for me to remove this print (tried to abort/delete it multiple times).
All seems to work though - I'm still able to print over the network. But the current Print Jobs just always shows this - which is not there.. 😕
At this very moment, I'm printing something completely different ...