Jump to content
Ultimaker Community of 3D Printing Experts


  • Content Count

  • Joined

  • Last visited

Everything posted by Orthopus

  1. Hi Smithy, Thank you for your answer. I will change the minimum layer time from 3s to 10s. About the printing temperature I've followed the guidelines from FormFutura. They advice temperature from 240°C to 260°C and I've tried 240, 250 and 260°C. I will try again at 240°C. I've enclosed the printer in a chest made from heat insulation material. I felt the temperature inside was much hotter than the room temp so I will lower it down. I've set the flow to 106% following guidelines from FormFutura, I will set it back to 100%. I will
  2. Hi everybody, We've just bought an Ultimaker 2 extended + and being new to the 3D printing world we are trying to print out simple objects with different filaments. I couldn't figure out the right settings to print out a micro catapult from Thingiverse with FormFutura TitanX filament (datasheet). Here are the settings of my last try : - Material : FormFutura TitanX White - Printing T° : 260°C - Build Plate T° : 85°C - Fan Speed : 20% - Regular fan speed : 5% - Max. fan speed : 20% - Nozzle Ø: 0.4 mm - Layer Height :
  • Create New...