Jump to content

PaulDF

Member
  • Content Count

    2
  • Joined

  • Last visited

Community Reputation

0 Neutral
  1. Thanks for the reply. I have updated the Firmware (twice) so will run the print again to see if it has solved the issue. Oddly, the bed leveling was/is fine, and all other prints smaller than 225mm tall have been printing fine, hence me thinking I was missing something in Cura.
  2. Dear Ultimakerists, I am having an issue using the full print height of our UM2E+. The model is just under 300mm, and I am printing from 0 i.e. not raft. The preview (below) shows that CURA (4.1.0) believes it will print but I have tried twice and the print stops at 225mm and the printer throws a "ERROR: tried to print out of printing area". I can see how the print might fail closer to the Z height limit but 75mm short seems strange. I have checked that the Printer Settings are set to 305mm Z height. It is very possible I am missing something very obvious, so ahve attached the project file. Any help is greatly appreciated. UM2E_part.3mf
×
×
  • Create New...

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!