Hi there, I'm trying to print a part with an overhang and I really want to use PVA as my support material. I'm not sure if it's my printer or the material itself but it seems like my printer doesn't like printing PVA. I've attached some pictures of how my print when and honestly non of the PVA was sticking to my build plate. I believe that is due to a lack of PVA printed during the brim step. In Cura it shows the PVA on the brim but when it prints, there is not PVA part of the brim. I've only gotten the PVA to behave once before. I've noticed t
Hi there, I am experiencing some dual extrusion issues. For some reason, my printer won't print my second material on the brim. In Cura, it shows under the preview tab that it will print the second material on the brim, but the actual print shows up without the second material on the brim. I attached a couple pictures. I just wanted to test the dual extrusion capabilities on my UMS5. The red PLA was my first material and the black PLA is my second material. As you can see from the pictures, the black PLA doesn't print out in the brim.