Brzozar2

Hi geert_2, Thank you for your reply. I have changed the layer thickness to the 0.1mm and these objects printed fine this time. I guess I'll stay with this layer height for this particular part for now. Thanks again.

Hello, I have recently noticed that my PLA Prints are poorly printed on the Ultimaker S5. I have used a 0.2 and 0.15mm prints settings , 0,4mm Print Core. Any ideas why the last few layers are sort of smeared/blurry? Please see attached photos. Thanks in advance for your help.

I had the same problem today with the freshly installed S5 bundle. After a successful print yesterday, this morning after a 5 mins of printing the ER80 popped out. I have switched the S5 off and on again and it was fine for another 4 hours of print until another ER80 appeared - very annoying. I have checked connections - no issues there. Anybody has any advise on this? Much appreciated in advance.