No, This is the simple LCD, non touch screen.
I may have not followed good ‘IT’ troubleshooting procedures. I altered to many things at one time..
I went back after the fact and tried the print again. Even so far as to ensure the pause at height command was entered. Also, sent the print via OctoPrint.
While i could not click to resume On the Ender, (Ender Jog Wheel) it did indeed pause when the resume was selected on OctoPrint. It was late enough that I didn’t have time to spin my compiled firmware back into the mix - something for tonight or this weekend.
In the past, I have not needed to compile my own firmware. So that was something new for me to work with. I’ll likely install the version. I compiled and repeat the testing process.