jteberle

Folks; I need some assistance/knowledge on how best to print with PETG. I have tried at 210 and 220 degrees Celsius and I still get a bunch of strings and little pieces breaking off. I am enclosing a picture. Any ideas on how to get a smooth finished product would be greatly appreciated. Thank you in advance.

Greg and all; Just wanted to tell you that your solution did work for me and to thank you again for the assistance.

Greg, thank you, will try this and get back to you. Thanks again

I have tried multiple times to get an .stl file to print on my snapmaker 2.0 A350 3d printer. the printer finally shows up with the checkmark, but the file won't successfully go over the network. So I copied it to a thumb drive and accessed it that way from the printer. I have a video, but don't know how to attach it to show what happens. Hopefully someone can help me get this correct. I can attach the gcode file. In the video, the printhead moves down, then moves to the forward corner, then makes small circles on the edge of the printbed, but I then stop it because it is just spewing filament and not making anything. Please help. I have had issue with Luban software, but was hoping Cura would be a better choice. CFFFP_Bowls_seven_1.gcode

I just downloaded Cura and have a snapmaker 2.0 A350 printer. The name of the printer shows up under local printers but how do I connect the software to the network so it sees the printer? Thanks for any help given!!