Apostoliszev

Hey, First of all thanks for the help. I noticed a problem. It doesn't load temperature in nozzle at first. Also when it moves away to change the material.. at the begging beacause there isn't such a distance between extruder and the build plate.. a lot of material is collected in the nozzle.. so it is created small balls of PVA.. and the nozzle carries them back to the main design and it destroyes my print. ...So should I try to do it with to "enable Prime Tower" with my start/end gcode that i had posted in the beggining? CFFFP_3mf_forum.3mf

Hi, I am trying to print this model. My problem is that it prints the down axis with PVA instead of PVA. My 3D printer has a single extruder, so for that i have enabled a prime tower, so the PVA material gets cold and to have time to change from PVA to PLA. Any suggestions on what should I do? Thanks a lot test2.3mf

Also i would like to ask you something else.. when i try to print this... it prints the bottom axis and the bottom part of the hub with pva... how can I control it and print it with PLA? Thanks a lot test_turbine.gcode

ok i will try it..thanks a lot

ok i am sending you my 3mf file. CFFFP_turbinecrown.3mf

Hello, I want to make a stucture with my d12/230. I am going to use 2 materials:PLA,PVA. PVA is my support. During my printing when its changes ... for example from PVA to PLA ...my extruder moves to the corner.. it is changing the material and then it continues printing. But as I have one single extruder i have noticed that a little amount of PVA printing with my PLA so my structrure collapses when i put it into water. Is a solution to keep my extruder more time at the corner so it can put away ALL of the previous material?? If yes... does anyone knows how to change the gcode? Thanks a lot

Good moring. I tried to put the definition file you posted and my temps loading perfectly. But when it comes the time to print, my extruders does not move from the up right corner and the printer is printing on the air. I post the gcode file. WD4S_spiral_kwnikosswlhnas.gcode

Ohh I am sorry. I will post you know the gcode from cura. I posted gcode from replicatorG by mistake. test_gcode.gcode

Yes it is prossible to preheat the Wanhao. thread.gcode

Temperatures does not load again.... I don't know what should I do, maybe my printer has a problem.. I think my settings are right.. Should I do something else, that i do not understand?

My printer is like as the photo I had uploaded earlier, so there is an offset and i will to find how much i should write. Thank you.

I downloaded cura again and it works. Now i have to see if the temperatures are loading. Can i ask you sth? In the settings of extruders, should I put a value on? Nozzle offset x: Nozzlet offset y:

Hello guys again. I am trying to put into the recourses file, a new printer definition and to add the second extruder that i found on github: https://github.com/fettesps/WanhaoDuplicator4S-Cura on my duplicator 4s. I deleted the 4.13.1 version because it didn't load me the temperatures and i tried on 3.6,4.2,4.2.1 as the guy on github tried. But although i copy the definition,extruder definitions, into the recources files, cura does not recognize the second extruder. Has anyone any idea on how i can fix it? Thanks a lot

ok thanks a lot. I am gonna try sth. The truth is that because the printer is old, it has a lot of problems.

No i dont't have Dual Extruder firmware installed.