Thank you for the work, solved a problem I've been battling for a while. A vertical wall, where a portion of it is slightly off vertical (2 degrees), on that section, there is a 4mm tab, at a right angle. I want supports on the base of the model, so tree supports were the only way to go. But could NOT get them to support the overhang. A support would go up, and touch the very edge, but NOT support it. If I added an overhang that was 90 (from vertical), in addition. ALL get supported. designed in Solidworks, sliced in Cura 5.1. When searching for a solution, I happened to come across this 5.3 pre-release.
I also like the cleaner design.