trevorlaurencehill

When I change the nozzle setting in cura and slice, the ultimaker still displays the file with 0.4 nozzle. I have changed it to 0.6 in cura but when you scroll to the file it says 0.4 and prints with bad extrusion. I have two machines. Both have the same problem. 1 has marlin firmware and the other has the bondtech firmware. Am I being dumb or can anyone else shed some light on why this may be happening?

Thank you. I can't find their instructions on their website. I have opened pronterface though and can change the esteps but I can't seem to change the speed without going into the firmware itself.

I have installed a bondtech QR extruder to my ultimaker 2 extended. I have updated the firmware to the bondtech firmware and have then factory reset the machine as instructed but the filament is only being pushed half way through when it restarts and asks to insert the material. It seems that the speed or esteps are only at 50%. Has anyone had any issues with this set up? Or have any advice as to what I can do to fix it. I think I can amend the esteps but it says I shouldn't have to do that so why would it be happening?