3DCloner

Hello everybody! At first I managed to solve this problem by checking the "Print Thin Walls" option in version 5.3.0. Remembering that this option was unchecked in version 5.2.1 and earlier and did not present problems. I relied on the following thread: https://github.com/Ultimaker/Cura/issues/14811#issuecomment-1523164974 Below is the analysis of the gcodes on the website: https://www.gcodeanalyser.com/#

I understand, thank you for your attention, I am a printer manufacturer and I use the Ultimaker Cura as a slicer, hence the insistence on an answer, as my customers may end up having this problem too. If I manage to somehow solve it, I'll update the post for any need.

Hey guys! Any more suggestions?

@nallath I did the test with "Max Resolution" at 0.40 and 1.00 and the behavior is the same. I noticed that she doesn't do that in Skirt, only in Perimeters. 3STG4_CILINDRO TOP_5.3.0_max_res0.4.gcode3STG4_CILINDRO TOP_5.3.0_max_res1.0.gcode

First thanks for the reply. About communication, I have a Duet 2 Wifi (32 bits) using the card that is on the motherboard. I've had cases of this stuttering, but here the files are all on the same SD, under the same conditions, one hangs and the other doesn't. So I believe it's not the printer, but some cura configuration, because with 5.2.1 is running normally. Attached is the print of the "Mesh Fixes" of version 5.2.1 and 5.3.0

Note: I noticed that gcode 5.3.0 has around 3k lines less than the others, it might help to solve

Hello! I installed version 5.3.0 of cura, it slows down on perimeters. I used exactly the same parameters in the previous version 5.2.1 and 5.1.1, same stl, I removed all the settings, I installed it again, but I couldn't solve it. Even the plugins already exclude all thinking that could have influenced. Does anyone know what can it be? Here is the link on my google drive of videos of the printer doing perimeters in 5.2.1 (more fluid) and 5.3.0 (keeps pausing). https://drive.google.com/drive/folders/1CK0J5uDkHyqsHHMukNj9YMUIsk9IppuP?usp=sharing 3STG4_CILINDRO TOP_5.1.1.gcode 3STG4_CILINDRO TOP_5.2.1.gcode 3STG4_CILINDRO TOP_5.3.0.gcode

OK! I understand! Thanks, I'll try these steps, thanks!

Hello, I am a 3d printer manufacturer. Inside Github I already made a "pull request" of my files. What should I still do to get my printers added to the program?