mdcyntst

Here's another interesting follow up post config corruption. Now whenever I load an STL file. They are shadowy ghostly outlines until I slice them (barely visible and difficult to determine z-axis setting). They used to load as a solid yellow figures.

hmmm. Just found it. I had to "activate" one of my printers and the profiles came back.

restarted ultimaker cura 5.5 on linux and got corrupt messages. I've got the printer configs back, but apparently I'm missing a bunch of profiles. I'm relatively new to 3d printing. I've been making good progress building things in freecad and printing. However I don't have some settings I used a lot. Specifically I had a bunch of settings for normal, draft, fast, extra fast, fine etc. Since the config configuration, they have disappeared. Interestingly I never created them, they came default. Not sure how I enabled them, but I can't find them anymore. Any guidance is appreciated.

I can't figure out where to change/remove this feature. Everytime I save a file, it prepends "AV_" to the filename. Can I change or stop this behavior? Where? Thanks in advance.

I second this issue. Use an environment variable CURA_WORKDIR=xxx, or recent_dir (vs recent_files). Every time I do any kind of file access (open, save, etc) , I have to navigate all over the place. It also does'nt remember the filename I opened, so saving a slice requires navigating and naming. I know that sounds petty, Just a feature request.