Walls are too big

[adhome 0]

Hello,

if I print a cylinder with a hole in it, the hole will be a little too small.

Cylinder is d=30.5mm. And the printed cylinder will have 30.1mm

A hole of 7mm in it and a layer size of 0.2 the Hole will only have 6.5mm

A 26.4mm Hole will have 25.9mm

Material is PLV. Skin enabled.

The Material amount is good.

It looks like, that walls are general too big. Is there a setting or trick to skale the model to fit better (not in Z)?

Thanks

[Daid 306]

The difference in model hole size and actual hole size is mostly due to shrinkage of the material. This shrinkage depends on the size of the hole and the things printed around it. So a general scale factor is not the best solution, the best solution is to modify your model and adjust the parts there. Because other features in your model will shrink differently.

[rewolff 0]

The above post is SPAM trying to promote their website, hoping to trick moderators into leaving it there with the formulation of the message like that. I was tricked until I couldn't find any link....