Jump to content
Ultimaker Community of 3D Printing Experts

Dual Extrusion Switch Amount


inventabuild

Recommended Posts

Posted · Dual Extrusion Switch Amount

I looked at the gcode and it appears that after an extruder is done with its layer that it only retracts by the Dual Extrusion Switch Amount and not by Retraction Distance + Dual Extrusion Switch Amount.

Please confirm the retiring extruder only retracts by the Dual Extrusion Switch Amount because I am trying to avoid jams in my hot end which would occur if it retracts too great a distance.

  • Link to post
    Share on other sites

    Archived

    This topic is now archived and is closed to further replies.

    ×
    ×
    • Create New...