Jump to content
Ultimaker Community of 3D Printing Experts
inventabuild

NextX and NextY G-Code Variables For Positioning Hot End

Recommended Posts

Does Cura recognize NextX and NextY g-code variables for positioning the hot end. When dual extruding and I'm cooling down the retiring hot end and warming up the active hot end I would like to position the hot end over the Ooze Shield to minimize oozing on the print. Doing this w/ NextX and NextY would make this possible.

Are these variables currently available. If not, can the Cura developers please add this functionality?

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!