1. Check if the pulleys sit tightly on the rods
2. Make sure the belt tension is reasonable so neither the x nor the y motor does skip steps.
I've checked after
and they are not loose
it virked not
what should I do
1. Check if the pulleys sit tightly on the rods
2. Make sure the belt tension is reasonable so neither the x nor the y motor does skip steps.
I've checked after
and they are not loose
it virked not
what should I do
Make sure the long belts are also not too tight.
Make sure the long belts are also not too tight.
they are not too tight
Recommended Posts
Dim3nsioneer 558
1. Check if the pulleys sit tightly on the rods
2. Make sure the belt tension is reasonable so neither the x nor the y motor does skip steps.
Link to post
Share on other sites