Jump to content

Effing Fluff Support!

benoit

By benoit
in UltiMaker 3D printers

 Share

Recommended Posts

benoit

benoit 0

Posted
Posted · Effing Fluff Support!

* Not sure if this goes in Netfabb or trouble shooting section

Hi all,

I'm having a problem with support structures (Fluff, Weak Fluff and Strong Fluff), they all seem to fail to print.

Have a look at the photo, this is in Fluff mode.

The first layer sticks nicely, but everything else turns out badly.

Would it perhaps be too hot?

Please advise.

thanks

benoit.

    • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
     Share
    Go to topic listing

    • Our picks

      • UltiMaker Cura 5.4 stable released

        UltiMaker Cura 5.4 stable released

        ArunC posted a topic in UltiMaker Cura,

        The full stable release of UltiMaker Cura 5.4 is here and it makes it easier than ever to remove brims and supports from your finished prints. UltiMaker S series users can also look forward to print profiles for our newest UltiMaker PET CF composite material!
          • Like
        • 58 replies
        MariMakes

        Picked By

        MariMakes,
      View All
    ×
    ×
    • Create New...