Jump to content

Ardunio Programming and Pic micro controllers with PWM Programming

bob-hepple

By bob-hepple
in Coffee corner

 Share

Recommended Posts

bob-hepple

bob-hepple 59

Posted
Posted · Ardunio Programming and Pic micro controllers with PWM Programming

Hi All

I know this is off topic but I suspect there are people hear who might be willing to help me with a Project.

I am building a Devise for the Disabled (none for Profit) which uses a Pic Micro-controller 12F683. Controlling a 12v DC motor. I need some help with the programming side and the electronic circuit, I have somethings in place but it needs tweaking, is there anyone out hear that would be willing to Help. If so let me know and we could PM.

sorry to the community for putting a bit of a bizarre message up. But I think this is exactly where I would find the talent and skills needed.

Thanks

Bob

    • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
     Share
    Go to topic listing

    • Our picks

      • UltiMaker Cura 5.7 stable released

        UltiMaker Cura 5.7 stable released

        ArunC posted a topic in UltiMaker Cura,

        Cura 5.7 is here and it brings a handy new workflow improvement when using Thingiverse and Cura together, as well as additional capabilities for Method series printers, and a powerful way of sharing print settings using new printer-agnostic project files! Read on to find out about all of these improvements and more. 
         
          • Like
        • 18 replies
        MariMakes

        Picked By

        MariMakes,

      • Release Notes: S-Line Firmware 8.3.0 (Latest)

        Dustin posted a topic in Firmware,

        S-Line Firmware 8.3.0 was released Nov. 20th on the "Latest" firmware branch.
        (Sorry, was out of office when this released)

        This update is for...
        All UltiMaker S series  
        New features
         
        Temperature status. During print preparation, the temperatures of the print cores and build plate will be shown on the display. This gives a better indication of the progress and remaining wait time. Save log files in paused state. It is now possible to save the printer's log files to USB if the currently active print job is paused. Previously, the Dump logs to USB option was only enabled if the printer was in idle state. Confirm print removal via Digital Factory. If the printer is connected to the Digital Factory, it is now possible to confirm the removal of a previous print job via the Digital Factory interface. This is useful in situations where the build plate is clear, but the operator forgot to select Confirm removal on the printer’s display. Visit this page for more information about this feature.
          • Like
        • 0 replies
        MariMakes

        Picked By

        MariMakes,
      View All
    ×
    ×
    • Create New...