Jump to content

strange problem with small piece


simmosam

Recommended Posts

Posted · strange problem with small piece

Hello,

since a month I'm printing and with good success. Since I still have problems with plugs (even with Hotend V2.0!) I wanted to print the Bertho extruder update. I can print nearly all the parts but the Yoke part gives me a headache! One leg of this part is ok, but the other (right leg) won't print well, it seems that there's too much material for this. I print with the standard Cura parameters with 0.1 layer height. the parameter for extrusion i needed to adjust (100mm extruded was only 95mm measured; param adjusted to 867.xxxxxx)

The problem als occur when I tried to print Z_axis_long_body from http://www.thingiverse.com/thing:19912 th four islands are totally crap, it looks to me that these are being made with too much material.

Any Idea what is wrong?

Greetings,

Sam

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
    • Our picks

      • UltiMaker Cura 5.4 stable released
        The full stable release of UltiMaker Cura 5.4 is here and it makes it easier than ever to remove brims and supports from your finished prints. UltiMaker S series users can also look forward to print profiles for our newest UltiMaker PET CF composite material!
          • Like
        • 58 replies
    ×
    ×
    • Create New...