When you see infill showing through you probably need to check one box to fix it. It's in the basic screen go to fill density and click the ... next to that and check the box "infill prints after perimeters". That should fix that issue.
I am assuming that this suggestion is for 15.06, although I thought the picture showed the infill showing through on the part that had been printed using 15.02? I am currently using 15.02 (as I found 15.06 to be a bit buggy) and when I click the ... box next to fill density, the only boxes I can check are for 'Solid Infill top' and 'Solid infill bottom'. I have set 'Infill overlap %' to 0 but we are still getting the infill showing through and it would be good to stop that happening...
Recommended Posts
gr5 2,224
When you see infill showing through you probably need to check one box to fix it. It's in the basic screen go to fill density and click the ... next to that and check the box "infill prints after perimeters". That should fix that issue.
Link to post
Share on other sites