Jump to content

More shoes! Chris van den Elzen story

SandervG

By SandervG
in Official news

 Share

Recommended Posts

SandervG

SandervG 1,521

Posted
Posted · More shoes! Chris van den Elzen story

More shoes! But not from an established fashion designer this time. It is Chris van den Elzen's turn, lets see what a talented young designer can bring to the table with fresh new ideas combined with a new technology.

The world of high-end fashion is one that’s in perpetual change. It has a constant desire for original ideas and Chris van den Elzen is pushing the boundaries of the shoemaking art with 3D printed designs. The fashion world is loving every minute of it...

Read all about his story here

And you can watch his video below.

 

  • Like 1
Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing

  • Our picks

    • UltiMaker Cura 5.7 stable released

      UltiMaker Cura 5.7 stable released

      ArunC posted a topic in UltiMaker Cura,

      Cura 5.7 is here and it brings a handy new workflow improvement when using Thingiverse and Cura together, as well as additional capabilities for Method series printers, and a powerful way of sharing print settings using new printer-agnostic project files! Read on to find out about all of these improvements and more. 
       
        • Like
      • 18 replies
      MariMakes

      Picked By

      MariMakes,

    • Release Notes: S-Line Firmware 8.3.0 (Latest)

      Dustin posted a topic in Firmware,

      S-Line Firmware 8.3.0 was released Nov. 20th on the "Latest" firmware branch.
      (Sorry, was out of office when this released)

      This update is for...
      All UltiMaker S series  
      New features
       
      Temperature status. During print preparation, the temperatures of the print cores and build plate will be shown on the display. This gives a better indication of the progress and remaining wait time. Save log files in paused state. It is now possible to save the printer's log files to USB if the currently active print job is paused. Previously, the Dump logs to USB option was only enabled if the printer was in idle state. Confirm print removal via Digital Factory. If the printer is connected to the Digital Factory, it is now possible to confirm the removal of a previous print job via the Digital Factory interface. This is useful in situations where the build plate is clear, but the operator forgot to select Confirm removal on the printer’s display. Visit this page for more information about this feature.
        • Like
      • 0 replies
      MariMakes

      Picked By

      MariMakes,
    View All
×
×
  • Create New...