Jump to content

UM2 No Power - Brick works


dmolina

Recommended Posts

Posted · UM2 No Power - Brick works

Hello all,

I've been trying for the past weeks to bring this UM2 board I got to life. From the start, the board didn't accept firmware uploads, didn't comply when trying to burn the bootloader thru ISP or USBtiny programmers, but now, after countless hours, it seems I got those steps right, as I've been able to successfully upload Marlin into it.

The problem is, when I plug the brick and turn the board on, it doesn't turn on. When I supply power to the board thru either ICSP pins I get the green led and can communicate with it though.

I'm sure that the brick works because I've tested it in my printer, and the other brick I got doesn't turn it on either.

I wonder if there is anything happening with the relay, if I need to bring some pin HIGH or LOW somehow.

Any ideas?

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
    • Our picks

      • UltiMaker Cura 5.8 Stable released 🎉
        In the Cura 5.8 stable release, everyone can now tune their Z seams to look better than ever. Method series users get access to new material profiles, and the base Method model now has a printer profile, meaning the whole Method series is now supported in Cura!
        • 5 replies
      • Introducing the UltiMaker Factor 4
        We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications
          • Thanks
          • Like
        • 3 replies
    ×
    ×
    • Create New...