build support problem and aborting during print?

[JessyKang 0]

HI~

I am very starter 3d printing.

Would you anyone help me?

1. I set to have support for 7 fans, But 1 fan's support were not builted.

I tried to start again, save again even modeling again.

One side still empty.

What is problem with that?

[media-thumb=5162][/media-thumb]

2. Like question no1. If I want to abort the printing how can I?

there is no sign for aborting.

Just turn off or pull out SD card?

[media-thumb=5161][/media-thumb]

Thank you very much.

Edited September 11, 2015 by Guest

[Labern 775]

Hi

1. Can you share you file or show a screen shot of cura?

2. On the printer Select tune then abort