Start gcode for UM2

[greyltc 0]

Hi everyone. I've looked at the github repo for the firmware of the UM2: https://github.com/Ultimaker/Ultimaker2Marlin but I can't seem to find the gcode that defines the filament purging process that occurs just before the print. Can anyone show me where in the source tree that is?

Thanks!

[gpb01 23]

... maybe is not coded as a series of "gcode" commands, but directly as a "motor movements" instructions inside the firmware.

It runs if, at the beginning of gcode,  is found the statement ";FLAVOR:UltiGCode" ...

Guglielmo

Edited October 10, 2015 by Guest

[rigs 735]

https://github.com/Ultimaker/Ultimaker2Marlin/blob/master/Marlin/UltiLCD2_menu_print.cpp

And @gpb01 as right it's not "Gcode" but "Ulti-Gcode"

[greyltc 0]

Thanks folks!