-
Our picks
-
UltiMaker Cura 5.4 stable released
ArunC posted a topic in UltiMaker Cura,
The full stable release of UltiMaker Cura 5.4 is here and it makes it easier than ever to remove brims and supports from your finished prints. UltiMaker S series users can also look forward to print profiles for our newest UltiMaker PET CF composite material!-
-
- 58 replies
.thumb.jpeg.0b7a05eafc09add17b8338efde5852e9.jpeg)
Picked By
MariMakes, -
-
.thumb.jpeg.0b7a05eafc09add17b8338efde5852e9.jpeg)
Recommended Posts
Daid 304
Yes, and no.
Cura 12.08 ships with revision b67dacdc8f1bd489e058e16d92ba29c364b2a8e5 of that branch.
So the firmware shipping with Cura is older then that branch, you can still get the same Marlin version as in Cura by checking out the same revision from that branch.
There have been updates on that branch, including long-filename support for the UltiController. But those changes are not as well tested as the firmware shipping with Cura.
Link to post
Share on other sites