I figured out how to solve this.
I downloaded someone else's GCode settings and applied them. It's still a bit wonky, but i can at least get material to stick to the glass now.
I figured out how to solve this.
I downloaded someone else's GCode settings and applied them. It's still a bit wonky, but i can at least get material to stick to the glass now.
Uhhm... I would rather call this a work-around than a solution except you figured out which setting made the difference... In that case, please let us know so others may profit from this thread.
Edited by GuestHere's where I found some premade GCode files:
Recommended Posts
Dim3nsioneer 558
By setting temperature to 230°C? If you already have you should save the gcode to a file instead of starting the print and then check within the first lines what Cura writes in the M109 or M104 commands.
Link to post
Share on other sites