Jump to content

Inconsistent M6 washers on Ultimaker Heated Bed Upgrade?


amzeratul

Recommended Posts

Posted · Inconsistent M6 washers on Ultimaker Heated Bed Upgrade?

Hey all,

I've recently received my Heated Bed Upgrade for the original Ultimaker, and during the installation, I ran into an issue with the washers that go with the thumb screws underneath the springs. One of them looks exactly as described in the instructions (thick, with a rounded side), but the other two are thin and flat (see attached picture). I proceeded to build with those anyway, greasing and installing the flat ones on the front (with the single rounded one on the back).

I expect this to not be a biggie (haven't had time to do the firmware upgrade and testing), but is there anything I'm missing? Should I replace them with proper washers? If so, how would I go about getting those?

Thanks!

IMAG1679.thumb.jpg.7a98d0953cfc4f3ada85bf720d380230.jpg

IMAG1679.thumb.jpg.7a98d0953cfc4f3ada85bf720d380230.jpg

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
    • Our picks

      • UltiMaker Cura 5.4 stable released
        The full stable release of UltiMaker Cura 5.4 is here and it makes it easier than ever to remove brims and supports from your finished prints. UltiMaker S series users can also look forward to print profiles for our newest UltiMaker PET CF composite material!
          • Like
        • 58 replies
    ×
    ×
    • Create New...