UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
Another Cura release has arrived and in this 5.8 beta release, the focus is on improving Z seams, as well as completing support for the full Method series of printers by introducing a profile for the UltiMaker Method.
We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications
Recommended Posts
3dcase 37
Hi all,
took sometime to find my way on the forum again....
A material question.
Yesterday I made my first roll of recycled PP filament.https://www.facebook.com/kees.deligt/videos/1154769167884844/?pnref=story
For a first try, did not look too bad.
But...
Any tips or tricks for printing?
I can't keep it stuck to the bed. tried temperatures from 70 to 110 C.
Using tape or gluestick.
Nothing seem to work....
Regards Kees
Link to post
Share on other sites