i have thew flex3drive and i want to configure in um2...

[david_easy 0]

i want to configure the nozzle hight.

now, when i level the bed, it going to high and collide with the nozzle.

cura version: 15.06.03

i think i have to do it in the um2 firmware using 3d printer control soft with usb.

can someone help me please?

thanks.

[SandervG 1,521]

Have you tried releveling your bed?

This can be done on your Ultimaker 2. By readjusting your bed-level you should be able to prevent it from colliding with your nozzle.

Good luck!