UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
In the Cura 5.8 stable release, everyone can now tune their Z seams to look better than ever. Method series users get access to new material profiles, and the base Method model now has a printer profile, meaning the whole Method series is now supported in Cura!
We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications
Recommended Posts
SandervG 1,521
Hi Zarro,
Thank you for your post.
Quite an early Christmas for you then? Regardless, it has already proven to be a merry one.
Now if we also fix this issue of you I am sure it will even be a merrier one.
Did you get any other reels of filament with your Ultimaker except the silver one?
It looks like there are some inefficiencies in your filament which cause these sparse layers.
I would advice you to try a different reel of filament / color.
Link to post
Share on other sites