Jump to content

Welche Steuerplatinen sind im UM2 eingebaut?

rasenmuster

By rasenmuster
in Deutsch

 Share

Recommended Posts

rasenmuster

rasenmuster 0

Posted
Posted · Welche Steuerplatinen sind im UM2 eingebaut?

Guten Abend =)

Bevor ich meinen UM2 kompett auseinander nehme, wollte ich lieber hier mal nachfragen, welche Steuerplatinen im UM2 eingebaut sind?!

Sowie auf dem Bild zusehen einmal ein Motherboard sowie das Frontpanel mit dem LCD Controller?

Seh ich das richtig, dass das Motherboard bereits Stepper Treiber bis 1,5A enthält und dass kein zusätzliches Arduino MEGA 2560 benötigt wird?

1,5A wären mir dann zuwenig, wenn ich Steppermotoren mit 1,7-2A betreibe...

Unbenannt3.thumb.JPG.8a966616c34669cdc85611652e522d57.JPG

Unbenannt3.thumb.JPG.8a966616c34669cdc85611652e522d57.JPG

    • Link to post
    Share on other sites
    Dim3nsioneer

    Dim3nsioneer 557

    Posted
    Posted · Welche Steuerplatinen sind im UM2 eingebaut?

    Die UM2-Schrittmotoren bzw. die Treiber sollten nicht mit mehr als 1300mA belastet werden; die Treiber sind also ausreichend. Der Arduino MEGA ist schon auf dem Board drauf.

    • Like 1
    Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
     Share
    Go to topic listing

    • Our picks

      • UltiMaker Cura 5.7 stable released

        UltiMaker Cura 5.7 stable released

        ArunC posted a topic in UltiMaker Cura,

        Cura 5.7 is here and it brings a handy new workflow improvement when using Thingiverse and Cura together, as well as additional capabilities for Method series printers, and a powerful way of sharing print settings using new printer-agnostic project files! Read on to find out about all of these improvements and more. 
         
          • Like
        • 16 replies
        MariMakes

        Picked By

        MariMakes,

      • Release Notes: S-Line Firmware 8.3.0 (Latest)

        Dustin posted a topic in Firmware,

        S-Line Firmware 8.3.0 was released Nov. 20th on the "Latest" firmware branch.
        (Sorry, was out of office when this released)

        This update is for...
        All UltiMaker S series  
        New features
         
        Temperature status. During print preparation, the temperatures of the print cores and build plate will be shown on the display. This gives a better indication of the progress and remaining wait time. Save log files in paused state. It is now possible to save the printer's log files to USB if the currently active print job is paused. Previously, the Dump logs to USB option was only enabled if the printer was in idle state. Confirm print removal via Digital Factory. If the printer is connected to the Digital Factory, it is now possible to confirm the removal of a previous print job via the Digital Factory interface. This is useful in situations where the build plate is clear, but the operator forgot to select Confirm removal on the printer’s display. Visit this page for more information about this feature.
          • Like
        • 0 replies
        MariMakes

        Picked By

        MariMakes,
      View All
    ×
    ×
    • Create New...